26 May 2002. SMS.
PBXGA (ZXLp-E1, ZXLp-E2, ZXLp-E3) Switch Settings
========================================================================
PBXGA-AA = ZXLp-E1 2MB 8-plane
PBXGA-BA = ZXLp-E2 8MB 24-plane
PBXGA-CA = ZXLp-E3 16MB 24-plane, 24-plane Z-buffer (stereo)
Change "-xA" to "-xN" for the Windows NT model. (Difference?)
========================================================================
The 4-position switch selects default sweep frequencies. Normally,
the switches are read only at initialization. In any case the behavior
of the card is determined by the software.
========================================================================
Presented as in the DEC manual:
-------------------------------
Switch Identification
---------------------
Stereo SW SW SW SW \ Video /
port 1 2 3 4 \ port /
------------------------------------------------ card -----
Switch settings
---------------
Up = Open = 1. Down = Closed = 0.
Switch Switch Pixel freq. Resolution Vertical
value 1 2 3 4 (MHz) freq. (Hz)
--------+---------+-------------+------------+------------
0 D D D D 130 1280x1024 72
1 U D D D 119 1280x1024 66
2 D U D D 108 1280x1024 60
3 U U D D 104 1152x900 72
4 D D U D 93 1152x900 66
5 U D U D 75 1024x768 70
6 D U U D 74 1024x768 72
7 U U U D 69 1024x864 60
8 D D D U 65 1024x768 60
9 U D D U 50 800x600 72
10 D U D U 40 800x600 60
11 U U D U 32 640x480 72
12 D D U U 25 640x480 60
13 U D U U 135 1280x1024 75
14 D U U U 110 1280x1024 60
15 U U U U Reserved
========================================================================
Follow this link to more DEC material.